Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
3ddrucker [2019/01/02 22:51] – [Sonstiges] mschubi3ddrucker [2019/01/23 19:12] – [Filament Deutschland] mschubi
Line 153: Line 153:
   * Extrudr - weiss nicht mehr   * Extrudr - weiss nicht mehr
   * Pulox (http://www.ebay.de/itm/Pulox-3D-Drucker-PLA-Filament-Rolle-1kg-1-75mm-/151856114068?var=&hash=item235b546994:m:mB_9-i5D5pDCRcYdMBs4s1A)   * Pulox (http://www.ebay.de/itm/Pulox-3D-Drucker-PLA-Filament-Rolle-1kg-1-75mm-/151856114068?var=&hash=item235b546994:m:mB_9-i5D5pDCRcYdMBs4s1A)
 +  * https://procatec.de
  
 http://www.lessner.at/3dprinter/filamentdatenbank/ http://www.lessner.at/3dprinter/filamentdatenbank/
Line 197: Line 197:
 https://github.com/altLab/photon-resin-calibration https://github.com/altLab/photon-resin-calibration
  
 +https://www.thingiverse.com/thing:3158693
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International